Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Systems of start, ignition
   + 8.1.1. Introduction
   + 8.2. Ignition system (petrol engines)
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


8. Systems of start, ignition

8.1. Systems of start of the engine and accumulator additional charge

8.1.1. Introduction
THE GENERAL DATA

The electric equipment system has working pressure of negative grounding of 12 volt.

On cars the accumulator which is demanding small maintenance service or not demanding maintenance service is established. The accumulator is recharged by the generator receiving a drive from a pulley of a cranked shaft.

The starter with preliminary gearing has involving relay which results a leading gear wheel in gearing with a gear wreath of a flywheel / a leading disk at engine start.


The prevention

At work with electric equipment system it is necessary to observe following safety measures not to damage semi-conductor devices and not to be traumatised.

Always remove rings, hours and other metal subjects at work with electric equipment system.

Do not mix a wire of connection of the accumulator.

Do not disconnect the accumulator, the generator, connecting wires or devices at the working engine.

Do not check generator work, concerning with a target wire of "weight" of the car.

Always disconnect a wire of the minus plug of the accumulator before work with electric equipment system.

Before use of the electrowelding equipment, disconnect the accumulator, the generator and all electronic blocks of management.