Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
- 1. The maintenance instruction
   1.2. The panel of devices Audi A6/A6 Avant, S6/S6 Avant
   1.3. Alarm and control lamps
   + 1.4. Installation of seats
   1.5. Electric window lifterи
   1.6. Steering wheel installation
   1.7. The ignition lock
   1.8. Switches
   1.9. Lever switches of light
   1.10. Screen wipers and washer
   1.11. Heating and ventilation
   1.12. The conditioner
   1.13. Installation of external mirrors
   1.14. Electric put external mirrors
   1.15. The Podemno-sdvizhnaja panel of a roof
   1.16. A folding cover of the refuelling hatch
   1.17. An automatic transmission
   1.18. The dynamic program of switching (DPS)
   1.19. The spare or emergency program
   1.20. Control lever positions
   1.21. The device kick-down
   1.22. Recommendations about driving
   1.23. A combination of devices
   1.24. Control lamps
   1.25. Symbols of red colour (1 degree priority)
   1.26. Symbols of yellow colour (2 degree priority)
   1.27. The onboard computer
   1.28. Switches
   1.29. System of maintenance of constant speed
   1.30. System of screen wipers and windscreen
   1.31. The automatic conditioner
   1.32. Vozduhovypusknye devices
   1.33. A control panel an independent heater
   1.34. Electronic blocking of differential (EDS)
   1.35. The control of level of oil
   1.36. The amplifier of steering drive / Servotronic, a regulator of a road gleam
   1.37. Cooling system
   1.38. A brake liquid
   1.39. Colour designations of safety locks
   + 1.40. Replacement of lamps
   1.41. Auxiliary tap
   1.42. Realisation of the starting help
   1.43. Car nameplate data
   1.44. The 4-cylinder engine in volume of 1,8 l
   1.45. The 4-cylinder engine in volume of 1,9 l
   1.46. The 5-cylinder diesel engine
   1.47. Recommended pressure in tyres
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


1.33. A control panel an independent heater
THE GENERAL DATA

And – the display

B – a yellow control lamp of readiness for programming of time of inclusion

C – a green control lamp of inclusion of a heater

D – a key of heating / of ventilation

Еcoin

Key of programming of time of the first inclusion

Key of programming of time of the second inclusion

Key for reading of real time

Operative inclusion and deenergizing of a heater or the fan for giving of fresh air

Installation of real time with return readout

Installation of real time with direct readout

Reading of real time

Press and keep a key . Indication is highlighted, while the key is pressed. At release keys it dies away. If, however, before it inclusion time it remains on indication still approximately within 2 seconds has been programmed.

Installation of real time

Press and keep a key .

Keys  (return readout) and  (direct readout) adjust hours on an actual exact times.

Adjustment key (D) on a mode of heating / of ventilation

Work in a mode of the independent fan

Typical variant of adjustment for a summer season:

At the pressed key the device works only as the fan for giving of fresh air, and the heater does not join. The control lamp () heater inclusions at work in a fan mode does not burn.

Inclusion and deenergizing, and also programming of time of start-up of the device in a mode of the independent fan are carried out the same as it is described more low for a heating mode.

Work in a mode of an independent heater

Typical variant of adjustment for a winter season:

At not pressed key the device works as a heater.

Inclusion and deenergizing of an independent heater

Before inclusion execute adjustment of system of heating and ventilation.

Key D establish in a mode of an independent heater.

Inclusion is carried out by key pressing. The heater will earn at once. At its inclusion the control lamp () burns.

Deenergizing is carried out by key pressing. The control lamp () thus dies away.


The prevention

After 60 mines of work in a mode of an independent heater the device is automatically switched off.


Programming of time of inclusion of a heater

Keys   also    it is possible to program two various times of inclusion of a heater within one days.

Press a key    or  . On the display there is an indication of a corresponding key. The control lamp (), confirming readiness of the programming device for work burns.

The necessary time of inclusion of a heater is set by keys of installation of time with direct and return readout. With increase in duration of deduction of these keys time readout is accelerated.

Approximately in 20 seconds after realisation of the given adjustment indication of programmed time dies away. However on the display there is number of a setting key    or   , confirming programming.

Key (D) establish in a mode of an independent heater.

Carry out heating and ventilation adjustment.

Cancellation / acknowledgement of programmed time of inclusion

For cancellation press a key    or   thus will go out key number on the display and a control lamp (), confirming readiness of the programmed device.

Acknowledgement of the programmed inclusion is carried out by pressing of keys    or   . The control lamp () Thus lights up.

Typical variants of adjustment

Cars with usual system of ventilation and heating

For work in a mode of an independent heater and the fan it is necessary to execute following operations on system adjustment:

For salon warming up turn a temperature regulator clockwise against the stop.

Воздухораспределитель establish in a mode of thawing of glasses or heating of space for feet, or between positions    and   .

The switch of operating modes of the fan establish in position II. On cars with usual system of heating and ventilation this switch cannot be established in position 0 as access of fresh air is thus blocked.

Cars with the automatic conditioner

Special adjustment it is not required. For thawing of glasses air moves automatically.