Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
- 3.2. Diesel engines
   - 3.2.1.2. Technical characteristics
      3.2.1.3. Sinhronizatsionnye labels timing
      3.2.1.4. Compression check
      3.2.1.5. A gazoraspredelitelnyj belt
      3.2.1.6. Натяжитель газораспределительного a belt, an asterisk
      3.2.1.7. Additional приводные belts
      3.2.1.8. A camshaft cover
      3.2.1.9. A camshaft epiploon
      3.2.1.10. An epiploon of an intermediate shaft
      3.2.1.11. Epiploons of a cranked shaft
      3.2.1.12. A head of cylinders
      3.2.1.13. Hydraulic pushers
      3.2.1.14. A flywheel
      3.2.1.15. Engine fastenings
      3.2.1.16. The oil pallet
      3.2.1.17. The oil pump and маслозаборный a branch pipe
   + 3.2.2. 5-cylinder engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


3.2.1.11. Epiploons of a cranked shaft FORWARD EPIPLOON OF THE CRANKED SHAFT

Replacement

PERFORMANCE ORDER
1. Remove an asterisk of a cranked shaft.
2. Drill two apertures in an epiploon, twist in them screws and take an epiploon.
3. Clean an epiploon groove, oil a new epiploon and establish it into place.

CASING OF THE FORWARD EPIPLOON OF THE CRANKED SHAFT

Lining replacement

PERFORMANCE ORDER
1. Remove an asterisk of a cranked shaft and the oil pallet.
2. Unscrew bolts and remove an epiploon casing.
3. Remove an old lining of a casing, if necessary take an epiploon.
4. Establish a new lining of a casing.
5. Establish an epiploon casing into place and tighten bolts.

BACK EPIPLOON AND CASING OF THE BACK EPIPLOON

Replacement

PERFORMANCE ORDER
1. Remove a transmission.
2. Remove a flywheel.
3. Remove an intermediate plate.

4. Remove the oil pallet.

5. Unscrew bolts and remove a casing of a back epiploon.
6. Unscrew bolts and remove an epiploon casing.
7. Remove old and establish a new lining of a casing.
8. Back epiploons are usually delivered with a protective plastic cap.
9. Oil a new epiploon and establish it together with a casing.
10. Tighten casing bolts.