Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
- 3.2. Diesel engines
   - 3.2.1.2. Technical characteristics
      3.2.1.3. Sinhronizatsionnye labels timing
      3.2.1.4. Compression check
      3.2.1.5. A gazoraspredelitelnyj belt
      3.2.1.6. Натяжитель газораспределительного a belt, an asterisk
      3.2.1.7. Additional приводные belts
      3.2.1.8. A camshaft cover
      3.2.1.9. A camshaft epiploon
      3.2.1.10. An epiploon of an intermediate shaft
      3.2.1.11. Epiploons of a cranked shaft
      3.2.1.12. A head of cylinders
      3.2.1.13. Hydraulic pushers
      3.2.1.14. A flywheel
      3.2.1.15. Engine fastenings
      3.2.1.16. The oil pallet
      3.2.1.17. The oil pump and маслозаборный a branch pipe
   + 3.2.2. 5-cylinder engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


3.2.1.5. A gazoraspredelitelnyj belt Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. To remove the top cover of a belt, unscrew screws.
3. Get inserts and disconnect latches.
4. Uncover.
6. Remove приводные belts and a pulley of the water pump.
7. Establish piston N1 in ВМТ.
8. Remove a pulley of a cranked shaft.
9. Remove the bottom cover газораспределительного a belt.
10. Loosen the a bolt натяжителя also remove газораспределительный a belt.

Check

Examine a belt on presence of pollution by greasing or oil, and also on presence of deterioration or damages. If necessary replace a belt.

Installation


PERFORMANCE ORDER
1. Loosen the a bolt of an asterisk of a camshaft and slightly shift an asterisk from a shaft.
2. Put on a belt asterisks.
3. Put on a belt a pulley натяжителя.
4. Pass a belt under the bottom pulley.
5. Get the blocking probe from an asterisk of the fuel pump.
6. Turn a pulley натяжителя clockwise to combine labels on a pulley and on a nave. Tighten a counternut натяжителя.
7. Tighten a bolt of an asterisk of a camshaft.
8. Establish the remained details.