Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
- 10. Brake system
   + 10.1.2. Shock-absorbers
   + 10.2. Technical characteristics
   10.3. Prorolling of hydraulic system
   10.4. Hydraulic tubes and hoses
   10.5. Brake overlays of forward brakes
   10.6. Brake overlays of back wheels
   10.7. Brake колодки back brakes
   10.8. A brake disk of a forward wheel
   10.9. A brake disk of a back wheel
   10.10. A brake drum of a back brake
   10.11. A support of a forward brake
   10.12. A support of a back brake
   10.13. The wheel cylinder of a back brake
   10.14. The main brake cylinder
   10.15. A brake pedal
   10.16. The vaakuumnyj amplifier
   10.17. The vacuum valve of a servoamplifier
   10.18. A rope of a manual brake
   10.19. The lever of a manual brake
   10.20. The valve of adjustment of pressure in a contour of back brakes (till 96 of century)
   10.21. The switch of fires of a stoplight
   10.22. The general description of system of antiblocking of brakes (ABS)
   10.23. System ABS elements
   10.24. The vacuum pump (diesel and petrol engines in volume 2,3)
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

10.12. A support of a back brake

THE GENERAL DATA

The prevention
On models with ABS disconnect the accumulator before the work beginning to prevent air hit in module ABS.

Removal

PERFORMANCE ORDER

1. Remove a back wheel.

2. Disconnect a rope from the lever of a manual brake on a support.

3. For reduction of losses of a brake liquid remove a cap of a tank of a brake liquid and tightly close a mouth a polyethylene film or press corresponding brake hoses.

4. Disconnect a brake tube from a support.

5. Turn off bolts of fingers of a support and remove a support from the car.

Partition
The prevention
The mechanism of a manual brake is not subject to repair. If it is faulty, it is necessary to replace a support.

PERFORMANCE ORDER

1. Clear a support of a dirt and a dust.

2. Get the piston, having turned it counter-clockwise.

3. Remove duster and consolidation of the piston from the support cylinder.

4. Remove fingers of a support and covers of fingers.

5. Carefully clear all elements in methyl spirit or a pure brake liquid. Examine all elements and replace worn out or damaged elements.

6. At assemblage check up, that all elements were absolutely pure.

7. Grease new consolidation and establish it in a flute in the support cylinder.

8. Establish duster on the piston and insert the piston into a support, rotating it clockwise.

9. Establish fingers and covers into place.

Installation

Installation is spent upside-down removals.