Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
- 11. Suspension brackets, a steering
   11.2. Technical characteristics
   11.3. The general description of adjustment of wheels
   + 11.4. A forward suspension bracket
   - 11.5. A back suspension bracket
      11.5.2. Bearings of a nave of a back wheel
      11.5.3. A pin of a back wheel
      11.5.4. A rack of a back suspension bracket
      11.5.5. Cross-section draught of a back suspension bracket
      11.5.6. The stabilizer of cross-section stability of a back suspension bracket
      11.5.7. A cross-beam of a back suspension bracket
      11.5.8. System of adjustment of height of a back suspension bracket
      11.5.9. Elements of system of adjustment of height of a back suspension bracket
   + 11.6. A steering
   + 11.7. Semiaxes
   11.8. Easily and easy
   11.9. Maintenance service of system of a steering
   11.10. Diagnostics of malfunctions of system of a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


11.5.4. A rack of a back suspension bracket Removal
PERFORMANCE ORDER
1. Remove a corresponding wheel.
2. Disconnect a hydraulic tube from a suspension bracket rack if it is necessary.
3. Establish a jack under a back axis.
4. Turn off a fixing nut and remove a bolt, крепящий a rack to a back axis.
5. Turn off nuts of the top fastening and remove a rack.

Installation

Installation is spent upside-down removals.

Repair

PERFORMANCE ORDER
1. Remove a rack and clear it. Mark position of installation of a fixing plate, a spring, the bottom saddle and the shock-absorber.
2. Compress a spring by means of compressors.
3. Turn off a fixing nut and remove the plug, a fixing plate, the top saddle and a spring.
4. Remove connection of a hydraulic tube if it is necessary, then remove a washer, an emphasis, the protective plug, a cap and the bottom saddle of a spring.
5. Examine the shock-absorber on presence of leak or damages and check up its work.
6. Gathering it is spent upside-down. At rack assemblage check up, that the emphasis on the bottom saddle of a spring (it is specified by an arrow) has been established at an angle in 90 ° to an axis of the bottom fixing bolt.