| 1. Remove a protective casing of a fuel tank and disconnect ropes of a manual brake. |
|
2. Disconnect brake tubes and remove ropes, wires and brake tubes from fastenings on a cross-beam.
|
| 3. Check up, that all elements have been disconnected and did not disturb to cross-beam removal. |
|
4. Turn off fixing nuts and bolts, fixing suspension bracket racks to a cross-beam. |
| 5. Turn off fixing bolts of a support and remove a support from a rack. |
| 6. Turn off a fixing nut and remove a bolt, крепящий cross-section draught in a suspension bracket cross-beam. |
|
7. Turn off and remove шарнирные bolts and remove a cross-beam. |
|
8. Examine plugs of fastenings and replace them if it is necessary. At installation of plugs check up, that the central line In between cuts was at an angle 90°±4 ° to an axis of longitudinal draught And. |