Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1.1.2. Technical characteristics
      3.1.1.3. Sinhronizatsionnye labels timing
      3.1.1.4. Compression check
      3.1.1.5. A gazoraspredelitelnyj belt
      3.1.1.6. Натяжитель газораспределительного a belt, an asterisk
      3.1.1.7. Additional приводные belts
      3.1.1.8. A camshaft cover
      3.1.1.9. A camshaft epiploon
      3.1.1.10. An epiploon of an intermediate shaft
      3.1.1.11. Epiploons of a cranked shaft
      3.1.1.12. A head of cylinders
      3.1.1.13. Hydraulic pushers
      3.1.1.14. A flywheel
      3.1.1.15. Engine fastenings
      3.1.1.16. The oil pallet
      3.1.1.17. The oil pump and маслозаборный a branch pipe
   + 3.1.2. 5-cylinder engines
   + 3.1.3. 6-cylinder engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


3.1.1.14. A flywheel Removal

PERFORMANCE ORDER
1. In models with a mechanical transmission remove a transmission and coupling.
2. In models with an automatic box remove a transmission.
3. Unscrew flywheel bolts, preliminary having stopped it.
4. Remove a flywheel.

Check

PERFORMANCE ORDER
1. Check up a flywheel on presence of deterioration and damages. At detection of those, address to the expert.
2. If you establish a new flywheel, on it there is only a label for piston N1 installation in ВМТ. It will be necessary for you to put on it a label for installation of a corner of an advancing of ignition (and = 14,6 mm).
3. Examine the needle bearing of a cranked shaft.

Installation

Installation is made in sequence, return to removal.

PERFORMANCE ORDER
1. Put герметизирующий structure on flywheel bolts.
2. Establish a leading disk (and = 27 mm ± 1 mm).
3. Tighten flywheel bolts.