Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
- 9. Transmission
   - 9.1.2. Technical characteristics
      9.1.3. Prorolling of hydraulic system of a drive of deenergizing of coupling
      9.1.4. Coupling adjustment
      9.1.5. A coupling pedal
      9.1.6. The main cylinder of a drive of deenergizing of coupling
      9.1.7. The working cylinder of a drive of deenergizing of coupling
      9.1.8. A disk of coupling and a casing
      9.1.9. The vyzhimnoj bearing and the lever
      9.1.10. Malfunctions of coupling
   + 9.2. A Mehnichesky transmission
   + 9.3. An automatic transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

9.1.6. The main cylinder of a drive of deenergizing of coupling

THE GENERAL DATA

Elements of the main cylinder of a drive of deenergizing of coupling

1. A tank
2. A hose
3. The plug
4. An adapter
5. Заглушка
6. The main cylinder
7. A bolt
8. A counternut
9. A plug
10. A pin
11. A lock ring
12. A tube
13. The plug
14. A washer
15. Fastening
16. The plug
17. A washer
18. A hose
19. The working cylinder
20. The prorolling valve
21. A cap
22. A connection nut

The main cylinder is located on a fixing arm of pedals of a brake and coupling.

Removal

PERFORMANCE ORDER

1. Remove the furnish panel.

2. Press the hydraulic hose going from a tank to the cylinder.

3. Disconnect a hydraulic hose and a tube from the cylinder.

4. Disconnect a pusher of the cylinder from a coupling pedal.

5. Turn off fixing bolts and remove the cylinder.

Repair

PERFORMANCE ORDER

1. Remove a cover and a pusher.

2. Remove a lock ring from the basis of the cylinder and remove a washer, the piston and a spring.

3. Clear all elements and examine them on presence of deterioration or damages. Replace the cylinder if it is necessary.

4. Grease new consolidations in a hydraulic liquid and establish them on the piston.

5. Insert a spring and the piston into the cylinder.

6. Establish a washer and a lock ring.

7. Establish a pusher and a cover. Tighten up a pusher plug so that the distance from the aperture centre on a plug to the main cylinder was 109,5±0,5 mm.

Installation

Installation is spent upside-down removals.