Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
- 9. Transmission
   - 9.1.2. Technical characteristics
      9.1.3. Prorolling of hydraulic system of a drive of deenergizing of coupling
      9.1.4. Coupling adjustment
      9.1.5. A coupling pedal
      9.1.6. The main cylinder of a drive of deenergizing of coupling
      9.1.7. The working cylinder of a drive of deenergizing of coupling
      9.1.8. A disk of coupling and a casing
      9.1.9. The vyzhimnoj bearing and the lever
      9.1.10. Malfunctions of coupling
   + 9.2. A Mehnichesky transmission
   + 9.3. An automatic transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

9.1.9. The vyzhimnoj bearing and the lever

THE GENERAL DATA

Elements of the mechanism of deenergizing of coupling (a transmission 01Е)

1. A transmission
2. Intermediate fastening
3. An epiploon
4. The directing plug
5. A bolt
6. The lever of deenergizing of coupling
7. A spring
8. A bolt
9. The vyzhimnoj bearing

Removal

PERFORMANCE ORDER

1. Remove a transmission.

2. Remove the lever of deenergizing of coupling from a spherical support. On a transmission 012 wring out a spring clip and remove the lever from a support.

3. Remove the bearing from the lever (a transmission 012).

4. On models with a transmission 01Е turn off a fixing bolt and remove an elastic plate. Remove the bearing and the lever.

Survey

Check up ease of rotation of the bearing. Replace the bearing if it is worn out.

Installation

PERFORMANCE ORDER

1. Grease a spherical support and the hinge of the lever of deenergizing of coupling with copper greasing. Grease выжимной the bearing.

2. On a transmission 012 establish a spring on the lever of deenergizing of coupling and insert a spring into an aperture.

3. Establish the lever and the bearing into place. Tighten a fixing bolt. Establish the lever on a spherical support so that the spring clip has fixed the lever.

4. On models with a transmission 01Е establish intermediate fastening on the lever, then establish the lever and the bearing into place. Tighten a fixing bolt.